![]() If you have not installed the light bulbs, you will hear two clicks. Let go of the buttons when the motor unit lights blink.wall-mounted control and then simultaneously press the push button on the wall-mounted control.While holding the Enter button, press and hold the Light button on the.Enter a four-digit personal identification number (PIN) of your choice on the keypad.How to program the keyless entry using the wall-mounted door control. The lock feature will always automatically turn off whenever the learn button activates.To deactivate the lock feature, press and hold the lock button for about two seconds, and the push light button will stop flashing.To engage this lock feature, long-press the lock button for about two seconds and the push button light will flash when the lock feature is on. This feature prevents you from operating the garage door with the hand-held remote controls, and the door will only activate from the door control, outdoor key switch, and the key-less entry accessories.Repeat the process for a 3-1/2 minute interval, and the light will blink thrice, up to the maximum of four blinks, to reset the time interval to 4-1/2 minutes.Press and hold the lock button again, and the light will blink twice, resetting the timer to 2-1/2 minutes.A single blink means that the timer has reset to 1-1/2 minutes. Long-press the Lock button until the light blinks.You can change how long you want the light on to 1-1/2, 2-1/2, or 3-1/2 minutes as follows:.Press the light button to turn the light off sooner. When you turn on the light button and activate the opener, the light will stay on for about 4-1/2 minutes.However, the light button will not work when the door is in motion. Press the light button to turn the garage door opener on or off.Press the button again to reserve the door during the closing cycle or stop the door during the opening cycle.Press the lighted push button to close and open the garage door.How to use the wall-mounted premium control console Lighted push button To restore the security feature, turn the lights on, press and hold the light button until it goes off, and then switch it on again. With the premium control console, you can switch off this feature as follows press and hold the light button until the light goes on and then off again. The security light will turn on when someone walks through the open garage door.The opener lights automatically turn off after four and a half minutes.The lights will stay on constantly when the light feature on the Motion Detecting Control console is activated.When power comes back after an interruption.When you initially plug the opener to power.The garage door opener lights will turn on under the following conditions:.If you release them too soon, the garage door will reverse. Press the buttons on these controls until the closing cycle is complete. However, you can close the door using the wall-mounted door control, the outdoor key switch, or Keyless Entry. ![]()
0 Comments
Leave a Reply. |